VARIANT1.01.503

NAME:
HELMET FOR ELECTRIC ARC WELDING (OPTO-ELECTRONIC)

COLOUR:
Grey

DESCRIPTION:
Helmet for electric arc welding. ABS. Sweat band. Easy ratchet adjustement of the headband. Liquid crystal filter included (110 x 90 mm). The VARIANT optoelectronic welding shield (VARIASL reference) comprises the VARIAHL helmet and the VARIALQ LCD auto-darkening solar lens and a protective screen (VARIAPP).

MATERIALS:
ABS LCD lens

INSTRUCTION FOR USE :

(1) Checking the product: Before using the optoelectronic welding shield for the first time, it is important to:

- Examine the product carefully and check its marking. Ensure that the product was manufactured by Delta Plus Group, that the helmet is marked VARIAHL and that it is fitted with its LCD lens marked VARIALQ;

- Examine the product carefully and ensure there is no damage, including on the inner and outer faces of the LCD screen, its solar sensor, its shell as well as its harness;

- Ensure that the whole product and its accessories are properly assembled and ready for use (see figure attached);

- Check the operation of the product by putting it as close as possible to an electric arc. It should switch automatically from the clear to the dark state, otherwise it is damaged;

- Remove the protective film from the screen before use.If the product is not conform, please contact us.

(2) Assembly: Our VARIANT product will probably not be assembled. If this is the case, refer to the diagram attached. The product should be assembled carefully (do not omit or leave any parts unassembled),

- Mount the headgear assembly;

- Fit the LCD lens in place. The VARIANT model is equipped with a VARIALQ reference LCD lens;

- The screws used to fix the LCD lens should be firmly tightened. Do not use the helmet with its lens incorrectly fixed;

- The protective screen should be fitted in the welding shield in front of the LCD lens. The outer face of the LCD lens should not come into direct contact with the welding arc.

(3) Adjusting the VARIAHL reference helmet: You can adjust the headgear assembly using its button (press and rotate) to tighten to fit your head size. Then try on the shield before using it for work. For a finer adjustment of your field of vision you can also modify the position of the stud located under the right-hand screw of the headgear assembly.

(4) Adjusting the VARIALQ reference LCD lens: The LCD lens is equipped with 3 adjustable buttons. For optimum

performances of the shield it is important to adjust them properly, according to your work conditions. The three functions are the shade adjustment to the dark state, switchover time and sensitivity