Application:

Welding and sewing separate pieces made of some hot melting materials, such as PVC fabric, PE canvas, outdoor poster banner, textile-ne, plastic pieces, and so on. It is also used to laminate and hem the margin in edge-works of the pieces.

Operation:

1. Choosing a working place relatively smooth before hemming and welding, leaving 30-40mm width of overlap edge for connecting the two pieces, fixing both ends of each piece with something such as adhesive tap or clamp.

2. Opening the package and checking the machine is not broken, plugging the machine, and turning on it by pressing the power key for 3 seconds, after these, adjusting the temperature and speed knobs according to the material quality and the thickness of your material, you could adjust the suitable hot-air blowing rate by press the switch key. Before working, you must pre-heat the machine about 2 minutes.

3. Bringing up the machine, placing the pressing roll at the end of overlap edge.

4. Handling the welding gun to left down, inserting the spout into the gap of the two overlap pieces, then the machine begin to run and joining the two pieces of the PVC material together automatically.

5. During welding, you could adjust the direction of treading suitably, letting the edge of the upper piece be in touch with the inner side of the welding spout’s neck.

6. After the machine going through the overlap edge and coming to the end, the two disjunctive pieces will be joined into one. Then handling up the welding gun to the right for stopping it.

7. Auto standby: The machine will turn off automatically for saving power and energy if there is no operation on it during 15 minutes. (automatically heat-off at the 12th minute, and power-off at the 15th minute) You should press the power key to turn it on again.

8. Manual power off: Be sure the welding gun is away from the material or ground, and press the switch for 3 seconds, it can stop working immediately, but the fan machine still shift 3 minutes to cool down the machine and protect the heating filaments.

Notice:

To prolong the life length of the heater strip, we strongly advise that you should cool down the machine after working. Be sure to adjust the hot-air blowing rate to maximum before turn off the machine.

To get a better bonding effect, the ground of should be smooth, hard and heat resistant. We suggest that the worker should do some test by joining the sample of the material and get the suitable speed, the suitable temperature and hot-air blowing rate.

Caution:

1. Improper operation and random disassemble are forbidden, to avoid fire disaster and electric shock, must ensure safety, do not use the machine if there is something wrong or unusual.

2. The working place should be flat and smooth and have enough strength to support the weight of the machine. Keeping the working place clean and ordered, do not use the wet clothes to wipe the machine when it is working.

3. The machine needs special tools to be repaired by professional staff when it is damaged. Be sure the power is shut down before repair.

4. Stopping the machine firstly and then shutting down the power, if anything wrong happen during the working time.

5. For perfect welding, the beginners should do more practices firstly, making sure that the power is off after working.

6. Prolong the life length of the machine, please do not let the machine work overtime.

7. Children should be protected form the machine.