Environmentally friendly land owned by the elastic plastic quality, is the safest surface material, color green elastic plastic surface has a wear-resistant, antimicrobial, low noise, moisture, heat and so on.

An environment-friendly flexible PVC plastic floor features:

1, environmental protection, no formaldehyde and harmful gas emissions, UV;

2, security, impact resistance, high resilience, protection of children can not be hurt wrestling;

3, cleanliness, easy maintenance, with water or ordinary cleaning can be easy to clean and maintain;

4, wear resistance, lasting wear and durability, color stability, and does not fade;

5, antimicrobial, and can not have germs, bacteria breeding;

6, stability, drainage performance, the all year round to keep surface dry, the floor no distortion, no cracking, not afraid of water, not bagging;

7, decorative, bright color layer can be designed and lively, happy, image and other kinds of patterns seamless, once formed, the overall sense.

Second, the scope of application: applicable to all types of vehicles, access, site, road, bridge laying, nursery ground, children's playground, tennis courts, basketball court, badminton courts, activity room, fitness room, a new alternative to traditional products .

Abrasion resistance: according to the needs of his clients have different and some degree of wear can be used for 20 years

 

Floor leather construction procedures and methods are:

 

First of all, a good measurement of the structure of the room size, measurements must be accurate and then the floor under the size of the cut leather. Attention should be slightly larger than the required width of cutting width, to facilitate the paving of the flowers and when Trim overlap.
Have laid a good floor leather should be not less than 15 °C Celsius room temperature for 24 hours under the conditions to make reform of the curly part of the floor can be fully extended, are prepared for the final paving.

Laying vinyl flooring application-specific binder. Paving, should be processed first floor of the room, first cleaning, to remove grease or dust and sand. Followed by the formation, uplift of the Department should be grinding the flat depression 107 Glue and cement can be used to adjust the weight ratio of 1:2 into a paste, leveling with a spatula, dried and then use sandpaper to break even. Ground smooth, clean, dry, you can glue a paving.

Glue is a sequence before the final paving, tools should be the tooth scraping the plastic sheet. When adhesive should be the size of the ground floor leather coating, coated paving a good one, and so order. Seams in the leather the width of 10 cm should be left without adhesive first to the final disposition of the seams.

Local surface coated rubber hand a good touch to the viscosity can be carried out after the paving and paste the sidelines when the note aligned with long-handled brush with the outside when the drive gas and compaction. Floor joints commonly used method of cutting overlapping spliced, overlapping width of about 5 cm is appropriate. Aligned with the long steel ruler overlap the center of the plate along the cutting blade of foot, and then remove the cut edge under the article (note there are two sides should be, do not forget to remove the following one), make up brush with a paint brush the right amount of glue in the joints, and then roller compacted to close seams. The remainder of plastic extrusion seams to rub clean, so as not to affect the appearance. Joint fluid then coated with a thin along the seams.

Lastly, we should check again whether the bubble is formed. If air bubbles, the air can be aspirated into the syringe and then compacted. Finally, remove detergent residue of glue on the floor leather marks, except can not afford to, use an alcohol wipe. This entire process will be completed.