1.Holding:suppouting the bottom of the machine with the four fingers of your right hand and them putting your thumb on the top of the machine for holding the machine tightly.

2.Threading: drawing the lisle softly from the bobbin and threading it from wendingAand the put it in the tension controllerB,Then threading it through the winding C.Putting the top of the lisle beside the needle,and then threading the lisle through the needle by using the threader.2-3certimetre.

3.Lift up the clothe fastening plate with right forefinger and putting the cloth(less than 0.8mmgauge)under the fastening plate,and then setting down the fastening plate.

4.Pressing the top of the machine up and down and do over,then the right hand should move to right step by step and let left hand hold the cloth the controll the direction

5.You can adjust the bolt for theoptimal habitus,adjust nut .

6.Drawing prolate distaff and thread spindle if you want to change and big clew.After threading again and readjusting the tight and loose of lisle,you can sewing again.

7.loose the setscrew with ascrewdriver and take off the old needle.Notice to let thd flat part of needle face the invariant setscrew.Correct direction and position of needle