Measure surface to be covered, cut the dimensions required allowing overlap of a
few centimeters, if surface to cover is large remove the protective paper from a
few centimeters and stick down. Apply carefully removing gradually the remainder
of the hand working from the center to the edges in order to expel any air bubbles.
Should any remain, pierce them with a pin and smooth down. If self-adhesive is not
stuck down properly lift carefully and put down again. If several lengths of self adhesive are to be laid they should be overlapped by approximately 1/2 centimeter.

This self-adhesive can be washed with soapy water. To remove old self-adhesive warm
surfaces using, for example, a hair dryer.